No need for compressed air!
Introducing exceptional freedom of installation in a super-compact size
Recommended Substitutes
Recommended Substitutes for Accessories/Options
| Discontinued product | Recommended substitute | |||||
|---|---|---|---|---|---|---|
| Product name | Product number/Part number | Last time buy | Product number/Part number | Product name | Remark | |
| Connector-attached cable | Product number: ER-QCC2 Part number: ER-QCC2 |
September 29, 2023 |  |
Product number:- Part number:- |
– | Sorry, no suggested alternative products. |
| Connector-attached cable | Product number: ER-QCC5 Part number: ER-QCC5 |
September 29, 2023 | |
Product number:- Part number:- |
– | Sorry, no suggested alternative products. |
| Attachment Bracket | Product number: ER-QMS1 Part number: ER-QMS1 |
September 29, 2023 | |
Product number:- Part number:- |
– | Sorry, no suggested alternative products. |
[Note]
The following applicable products and options are available continuously.
Order guide
Discontinued products [Order accepted till September, 2023]
| Note 1: | Typical value in condition of discharge distance 50 mm 1.969 in, center of the product, discharge frequency 50 Hz and air supply 60 ℓ/min.(0.3 MPa). |
|---|---|
| Note 2: | Typical value in condition of discharge distance 100 mm 3.937 in (ER-X001: 50 mm 1.969 in), center of the product, discharge frequency 50 Hz (ER‑X□HC:30 Hz) and no air supply. |
| Note 3: | Ion balance refers to the average value of plus and minus. The specification value is the typical one in condition used when ambient temperature change is less than ±10 ℃, ion balance is set after 30 minutes from the discharge start, the ion balance control function is set ON. |
| Note 4: | The ER-X001 and ER-X008 must be combined with the new-type ER-XC02 controller (produced from April 2014 on). Refer to “Identification of previous-type and new-type controllers and for the combination with the head”. |
| Note 5: | The ER-X□HC high / low temperature resistant type head can be used under temperatures from -60 to +200 ℃ -76 to +392 ℉. Be sure to use this head in combination with the new-type controller, ER-XC02 (produced from April 2016 on). Refer to “Identification of previous-type and new-type controllers and for the combination with the head”. |